If this is your first visit, be sure to check out the
FAQ by clicking the link above. You may have to
register or
login before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
| 25 JAN 2003 at 6:40pm |
rjnortonIntergalactic Janitor
Posts : 8
Joined: 14 JAN 2003
Status : Online | Hi KevinC, I found a walkthrough, but it just says "Turn on the Bunsen burner." I haven't played the game, but I have turned on a lot of bunsen burners. You have to first make sure the gas is turned on, and then either put a lit match on the top of the burner, or use a sparker to make a spark on top of the burner. A fancy one will let you adjust the air/gas ratio, but they probably didn't get into it that far.) Hope that helps!
|
| 26 JAN 2003 at 1:49am |
FnicodemIntergalactic Janitor
Posts : 11
Joined: 26 JAN 2003
Status : Offline | The answer to this one is actually quite simple -- and it *IS* in the walk-through... if you read it carefully.
You got to the lab by using the Zn (zinc) setting outside of the elevator. However, to do anything useful in the lab (and, in particular, to light the bunsen burner), you must set the control INSIDE the room to Zn as well!! This instruction comes at a page-break in the walk-through, and is easy to miss.
However, walk to the control on the *inside* of the room, near the door, and set it to Zn. The room will move to a new location -- sealed from the outside. Back away from the control, and when you go back to the lab table, the bunsen burner will light when you click on it.
(You'll need to return the control to its original setting (Cu) to move the room back to the position where you can exit the door.
|
| 26 JAN 2003 at 12:22pm |
shackmerIntergalactic Janitor
Posts : 2
Joined: 2 NOV 2002
Status : Online | actually there are 2 things that you need to get the bunson burner on. the wall knob has to also be set at zn, and make sure that at the big nose area (CNO) and make sure that the temperature switch is turned on to 270 degrees. I had it set to 70 degrees by accident and it wouldn't work. Hope this helps.
|
